![]() ![]() ![]() I inherited this instrument (wasn't there for the initial setup) but I looked in the method and in the "Injection/Injector" section, it is set to "Manual". I assume this is how the sampler tells the PC to "go ahead and start the GC and also collect data".ģ) Because of the cycle time of the GC and the sampling times, I can nest the samples (begin prepping for the next run before the current data collection is complete) but the GC sends the ready signal when it's ready to go and the sampler can start the whole thing again when it's ready. I assume this is for the GC to tell the sampler it's ok to start the sampling routine.Ģ) "Ser1" on the sampler is connected to one of the serial ports on the PC. I operate in SPME mode.ġ) "Remote" port on the GC is connnected to "Interface 1" on the sampler. JUst change the bungee cords every now and then. 6890/5973N with a LEAP Technologies CombiPAL sampler. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |